Node:headings on off, Previous:end titlepage, Up:Titlepage & Copyright Page



The @headings Command

The @headings command is rarely used. It specifies what kind of page headings and footings to print on each page. Usually, this is controlled by the @setchapternewpage command. You need the @headings command only if the @setchapternewpage command does not do what you want, or if you want to turn off pre-defined page headings prior to defining your own. Write an @headings command immediately after the @end titlepage command.

You can use @headings as follows:

@headings off
Turn off printing of page headings.
@headings single
Turn on page headings appropriate for single-sided printing.
@headings double
@headings on
Turn on page headings appropriate for double-sided printing. The two commands, @headings on and @headings double, are synonymous.
@headings singleafter
@headings doubleafter
Turn on single or double headings, respectively, after the current page is output.
@headings on
Turn on page headings: single if @setchapternewpage on, double otherwise.

For example, suppose you write @setchapternewpage off before the @titlepage command to tell TeX to start a new chapter on the same page as the end of the last chapter. This command also causes TeX to typeset page headers for single-sided printing. To cause TeX to typeset for double sided printing, write @headings double after the @end titlepage command.

You can stop TeX from generating any page headings at all by writing @headings off on a line of its own immediately after the line containing the @end titlepage command, like this:

     @end titlepage
     @headings off
     

The @headings off command overrides the @end titlepage command, which would otherwise cause TeX to print page headings.

You can also specify your own style of page heading and footing. See Page Headings, for more information.