Node:anchor, Previous:makeinfo Pointer Creation, Up:Nodes



@anchor: Defining Arbitrary Cross-reference Targets

An anchor is a position in your document, labeled so that cross-references can refer to it, just as they can to nodes. You create an anchor with the @anchor command, and give the label as a normal brace-delimited argument. For example:

     This marks the @anchor{x-spot}spot.
     ...
     @xref{x-spot,,the spot}.
     

produces:

     This marks the spot.
     ...
     See [the spot], page 1.
     

As you can see, the @anchor command itself produces no output. This example defines an anchor `x-spot' just before the word `spot'. You can refer to it later with an @xref or other cross-reference command, as shown. See Cross References, for details on the cross-reference commands.

It is best to put @anchor commands just before the position you wish to refer to; that way, the reader's eye is led on to the correct text when they jump to the anchor. You can put the @anchor command on a line by itself if that helps readability of the source. Spaces are always ignored after @anchor.

Anchor names and node names may not conflict. Anchors and nodes are given similar treatment in some ways; for example, the goto-node command in standalone Info takes either an anchor name or a node name as an argument. (See goto-node.)