Node:Using Info-validate, Next:, Previous:Running Info-Validate, Up:Running Info-Validate



Running Info-validate

To use Info-validate, visit the Info file you wish to check and type:

     M-x Info-validate
     

Note that the Info-validate command requires an upper case `I'. You may also need to create a tag table before running Info-validate. See Tagifying.

If your file is valid, you will receive a message that says "File appears valid". However, if you have a pointer that does not point to a node, error messages will be displayed in a buffer called *problems in info file*.

For example, Info-validate was run on a test file that contained only the first node of this manual. One of the messages said:

     In node "Overview", invalid Next: Texinfo Mode
     

This meant that the node called Overview had a `Next' pointer that did not point to anything (which was true in this case, since the test file had only one node in it).

Now suppose we add a node named Texinfo Mode to our test case but we do not specify a `Previous' for this node. Then we will get the following error message:

     In node "Texinfo Mode", should have Previous: Overview
     

This is because every `Next' pointer should be matched by a `Previous' (in the node where the `Next' points) which points back.

Info-validate also checks that all menu entries and cross references point to actual nodes.

Info-validate requires a tag table and does not work with files that have been split. (The texinfo-format-buffer command automatically splits large files.) In order to use Info-validate on a large file, you must run texinfo-format-buffer with an argument so that it does not split the Info file; and you must create a tag table for the unsplit file.