Node:Preparing for TeX, Next:, Previous:Requirements Summary, Up:Hardcopy



Preparing for TeX

TeX needs to know where to find the texinfo.tex file that the \input texinfo command on the first line reads. The texinfo.tex file tells TeX how to handle @-commands; it is included in all standard GNU distributions.

Usually, the installer has put the texinfo.tex file in the default directory that contains TeX macros when GNU Texinfo, Emacs or other GNU software is installed. In this case, TeX will find the file and you do not need to do anything special. If this has not been done, you can put texinfo.tex in the current directory when you run TeX, and TeX will find it there.

Also, you should install epsf.tex, if it is not already installed from another distribution. More details are at the end of the description of the @image command (see Images).

Likewise for pdfcolor.tex, if it is not already installed and you use pdftex.

Optionally, you may create an additional texinfo.cnf, and install it as well. This file is read by TeX when the @setfilename command is executed (see @setfilename). You can put any commands you like there, according to local site-wide conventions. They will be read by TeX when processing any Texinfo document. For example, if texinfo.cnf contains the line @afourpaper (see A4 Paper), then all Texinfo documents will be processed with that page size in effect. If you have nothing to put in texinfo.cnf, you do not need to create it.

If neither of the above locations for these system files suffice for you, you can specify the directories explicitly. For texinfo.tex, you can do this by writing the complete path for the file after the \input command. Another way, that works for both texinfo.tex and texinfo.cnf (and any other file TeX might read), is to set the TEXINPUTS environment variable in your .cshrc or .profile file.

Which you use of .cshrc or .profile depends on whether you use a Bourne shell-compatible (sh, bash, ksh, ...) or C shell-compatible (csh, tcsh) command interpreter. The latter read the .cshrc file for initialization information, and the former read .profile.

In a .cshrc file, you could use the following csh command sequence:

     setenv TEXINPUTS .:/home/me/mylib:/usr/lib/tex/macros
     

In a .profile file, you could use the following sh command sequence:

     TEXINPUTS=.:/home/me/mylib:/usr/lib/tex/macros
     export TEXINPUTS
     

On MS-DOS/MS-Windows, you would say it like this1:

     set TEXINPUTS=.;d:/home/me/mylib;c:/usr/lib/tex/macros
     

It is customary for DOS/Windows users to put such commands in the autoexec.bat file, or in the Windows Registry.

These settings would cause TeX to look for \input file first in the current directory, indicated by the ., then in a hypothetical user's me/mylib directory, and finally in a system directory /usr/lib/tex/macros.

Finally, you may wish to dump a .fmt file (see Memory dumps) so that TeX can load Texinfo faster. (The disadvantage is that then updating texinfo.tex requires redumping.) You can do this by running this command, assuming epsf.tex is findable by TeX:

     initex texinfo @dump
     

(dump is a TeX primitive.) Then, move texinfo.fmt to wherever your .fmt files are found; typically, this will be in the subdirectory web2c of your TeX installation.


Footnotes

  1. Note the use of the ; character, instead of :, as directory separator on these systems.