Huntgroups are special rules, that allow to alter processing of incoming
requests, depending on NAS IP address and port number they come
from. The rules are stored as a list of Matching Rules
(see section Matching Rule). Upon receiving a request, radiusd
scans this list sequentially until it finds an entry, such that
the conditions set forth in its LHS are matched by the
request. If such an entry is found, radiusd verifies that
the request meet the conditions described by RHS. If it
does not, the request is rejected. In short, a huntgroup requires
that any request matching its LHS must match also its
RHS. The Label part of the rule is not used in
comparisons, instead it is used to label huntgroups. All entries
with the same label form a single huntgroup. The special attribute
Huntgroup-Name can be used to request a match against a
particular huntgroup (see section Huntgroup-Name).
The huntgroups rules are defined in `raddb/huntgroups' file (see section Huntgroups -- `raddb/huntgroups').
Go to the first, previous, next, last section, table of contents.