Raduse Command Line Options

The following options modify the behavior of raduse:

-b

--brief

Start up in brief mode. In this mode only first line of information for each dialup line is displayed.

-d count

--display count

Show only count displays, then exit. A display is considered to be one update of the screen.

-D

--dump

Dump the statistics database to the standard output and then exit. This is for debugging purposes only.

-I

--no-idle-lines

Do not display idle lines. By default raduse displays all dialup lines.

-i

--interactive

Use interactive mode. In this mode any input is immediately read for processing. section Raduse Interactive Commands section for the description of commands usable in interactive mode. After processing each command the screen is updated immediately, no matter was the command understood or not. This mode is the default when the standard output is an intelligent terminal.

-n

--no-interactive

Use non-interactive mode.

-s num

--delay num

Specify delay in seconds between screen updates.

-w

--widen

Widen the time display fields to show the seconds.

-l

--list-nas

List the names and IP numbers of network access servers and then exit.

-h

--help

Display short usage summary.

Go to the first, previous, next, last section, table of contents.