Go to the first, previous, next, last section, table of contents.


Invoking

Invoke by running the program . Once started, reads commands from the terminal until you tell it to exit.

You can also run with a variety of arguments and options, to specify more of your debugging environment at the outset.

The command-line options described here are designed to cover a variety of situations; in some environments, some of these options may effectively be unavailable.

The most usual way to start is with one argument, specifying an executable program:

 program

You can also start with both an executable program and a core file specified:

 program core

You can, instead, specify a process ID as a second argument, if you want to debug a running process:

 program 1234

would attach to process 1234 (unless you also have a file named `1234'; does check for a core file first).

Taking advantage of the second command-line argument requires a fairly complete operating system; when you use as a remote debugger attached to a bare board, there may not be any notion of "process", and there is often no way to get a core dump. will warn you if it is unable to attach or to read core dumps.

You can run without printing the front material, which describes 's non-warranty, by specifying -silent:

 -silent

You can further control how starts up by using command-line options. itself can remind you of the options available.

Type

 -help

to display all available options and briefly describe their use (` -h' is a shorter equivalent).

All options and command line arguments you give are processed in sequential order. The order makes a difference when the `-x' option is used.


Go to the first, previous, next, last section, table of contents.