Go to the first, previous, next, last section, table of contents.


Commands for managing targets

target type parameters
Connects the host environment to a target machine or process. A target is typically a protocol for talking to debugging facilities. You use the argument type to specify the type or protocol of the target machine. Further parameters are interpreted by the target protocol, but typically include things like device names or host names to connect with, process numbers, and baud rates. The target command does not repeat if you press RET again after executing the command.
help target
Displays the names of all targets available. To display targets currently selected, use either info target or info files (see section Commands to specify files).
help target name
Describe a particular target, including any parameters necessary to select it.
set gnutarget args
uses its own library BFD to read your files. knows whether it is reading an executable, a core, or a .o file; however, you can specify the file format with the set gnutarget command. Unlike most target commands, with gnutarget the target refers to a program, not a machine.

Warning: To specify a file format with set gnutarget, you must know the actual BFD name.

See section Commands to specify files.
show gnutarget
Use the show gnutarget command to display what file format gnutarget is set to read. If you have not set gnutarget, will determine the file format for each file automatically, and show gnutarget displays `The current BDF target is "auto"'.

Here are some common targets (available, or not, depending on the GDB configuration):

target exec program
An executable file. `target exec program' is the same as `exec-file program'.
target core filename
A core dump file. `target core filename' is the same as `core-file filename'.
target remote dev
Remote serial target in GDB-specific protocol. The argument dev specifies what serial device to use for the connection (e.g. `/dev/ttya'). See section Remote debugging. target remote supports the load command. This is only useful if you have some other way of getting the stub to the target system, and you can put it somewhere in memory where it won't get clobbered by the download.
target sim
Builtin CPU simulator. includes simulators for most architectures. In general,
        target sim
        load
        run
works; however, you cannot assume that a specific memory map, device drivers, or even basic I/O is available, although some simulators do provide these. For info about any processor-specific simulator details, see the appropriate section in section Embedded Processors.

Some configurations may include these targets as well:

target nrom dev
NetROM ROM emulator. This target only supports downloading.

Different targets are available on different configurations of ; your configuration may have more or fewer targets.

Many remote targets require you to download the executable's code once you've successfully established a connection.

load filename
Depending on what remote debugging facilities are configured into , the load command may be available. Where it exists, it is meant to make filename (an executable) available for debugging on the remote system--by downloading, or dynamic linking, for example. load also records the filename symbol table in , like the add-symbol-file command. If your does not have a load command, attempting to execute it gets the error message "You can't do that when your target is ..." The file is loaded at whatever address is specified in the executable. For some object file formats, you can specify the load address when you link the program; for other formats, like a.out, the object file format specifies a fixed address. load does not repeat if you press RET again after using it.


Go to the first, previous, next, last section, table of contents.